Saradhi engineering has been a prominent entity for a long time who are engaged in providing high-quality Elastomeric Bridge Bearings in Hyderabad.Elastomeric Bridge Bearings plays an important role in bridges as well as building construction under pre-cast concrete beams, steel beam and also local load carrying components. Our Elastometric bearings are made mostly from high-quality rubber, claried with mild steel and sheets for maximum strength and also for endurance. These are made in various dimensions and also sizes in accordance to specification and also drawings.Unlike most other pads, bridge bearing elastomeric pads have no movable parts and can also goes to marked stiffening at very less temperature also. Offered bearings which provide adequate support to bridges and also for absorbing vibrations and preventing their deformation. Our products are manufactured by the specialist in accordance to international norms and standards. Further our quality assured bridge bearing elastomeric pads are available at market leading prices with us.
SARADHI COMPRESSION SEAL EXPANSION JOINT consists of steel armoured nosing at two edges of the joint gap suitably anchored to the deck concrete and a performed chloroprene elastomer compressed and fixed into the joint gap with special adhesive girder.
The compression seal will cater for a horizontal movement upto 40mm and vertical movement of 3mm.
It is recommended for simply supported or continuous spans right or skew moderately curved with maximum horizontal movement not exceeding 40mm.
SARADHI SLAB SEAL joint will consist of steel insert and elastomeric slab unit. This type of seal is recommended for simply supported or continuous spans, right or skew (less than 20 degree), moderately curved with maximum movement upto 50mm.
SARADHI SLAB SEAL expansion joint has been used for many years with a good success rate. However, the larger size of the joint tends to create more noise under traffic.
SARADHI Elastomeric joints are normally supplied in unit length and fixed to the deck using bolt anchors. If required tensioned cast iron bolts should be used to anchor this joint. If site drilled installations are used, the holes should be under reamed prior to fixing the bolts. An adequate length of the bolt should be de-bonded so that any relaxation over the bolt length does not result in complete loss of tension in the bolt.
It provides unique properties to withstand high water pressure in combination with large movements in all directions.
It is an ideal solution for joints where large gap movements are expected as a result of temperature effects and/or settlement Omega profile can be manufactured in a variety of sizes to fit almost any application. It is ideal for Metro rail projects
