Saradhi engineering are outstandingElastomeric Bearing Pads Suppliers in Hyderabad. Elastomeric Bearing Pads consists of one or more internal layers of Elastomer link to internal steel laminates. Our product cast as single unit in a mould and vulcanised under heat & pressure to supply for translation or rotation of the super structure by elastic deformation. Elastomeric Bearing are more easier to install bridge when compared to other types of bearings used. Saradhi engineering possess a rich industry experience of manufacturing high performance bearing pads,Seal joints,Rubber bearing.The main aim is to provide our customers with world class quality of rubber products. we are highly treasured in the industry due to sturdiness, low maintenance and seamless finish.Advantage of elastometric bearing pads is the robustness and corrosion free nature of these products, ease and convenience of installation, long service life and customized size to suit the bridge design.
SARADHI COMPRESSION SEAL EXPANSION JOINT consists of steel armoured nosing at two edges of the joint gap suitably anchored to the deck concrete and a performed chloroprene elastomer compressed and fixed into the joint gap with special adhesive girder.
The compression seal will cater for a horizontal movement upto 40mm and vertical movement of 3mm.
It is recommended for simply supported or continuous spans right or skew moderately curved with maximum horizontal movement not exceeding 40mm.Elastomeric Bearings Pads Suppliers
SARADHI SLAB SEAL joint will consist of steel insert and elastomeric slab unit. This type of seal is recommended for simply supported or continuous spans, right or skew (less than 20 degree), moderately curved with maximum movement upto 50mm.
SARADHI SLAB SEAL expansion joint has been used for many years with a good success rate. However, the larger size of the joint tends to create more noise under traffic.
SARADHI Elastomeric joints are normally supplied in unit length and fixed to the deck using bolt anchors. If required tensioned cast iron bolts should be used to anchor this joint. If site drilled installations are used, the holes should be under reamed prior to fixing the bolts. An adequate length of the bolt should be de-bonded so that any relaxation over the bolt length does not result in complete loss of tension in the bolt.
It provides unique properties to withstand high water pressure in combination with large movements in all directions.
It is an ideal solution for joints where large gap movements are expected as a result of temperature effects and/or settlement Omega profile can be manufactured in a variety of sizes to fit almost any application. It is ideal for Metro rail projects