Saradhi engineering is well-known manufacturer of compression seal for doors in Hyderabad.Compression Seal for doors is precompressed and is an aesthetically versatile option for high-stress joints. Compression seal consists of steel armoured nosing at two edges of the joint gap which is suitably anchored to the deck concrete and a performed chloroprene elastomer compressed and fixed into the joint gap with special adhesive girder.
Compression seals generate pressure due to seal with the help of the rubber due to rubber compressive deformation occurs. Compression seal which allows efficiently seal expansion joints. The elastomeric element is highly resistant to decline from exposure to weather, sunlight, oils and impact. Compression seal plays a major role in the fields of Interior and exterior wall expansion joint applications, Health Care, Transportation, Recreation, Retail, Commercial, Educational and Parking Garage. It is watertight, resists hurricane force wind, wax free, UV stable with low and high-temperature stability.
SARADHI COMPRESSION SEAL EXPANSION JOINT consists of steel armoured nosing at two edges of the joint gap suitably anchored to the deck concrete and a performed chloroprene elastomer compressed and fixed into the joint gap with special adhesive girder.
The compression seal will cater for a horizontal movement upto 40mm and vertical movement of 3mm.
It is recommended for simply supported or continuous spans right or skew moderately curved with maximum horizontal movement not exceeding 40mm.
SARADHI SLAB SEAL joint will consist of steel insert and elastomeric slab unit. This type of seal is recommended for simply supported or continuous spans, right or skew (less than 20 degree), moderately curved with maximum movement upto 50mm.
SARADHI SLAB SEAL expansion joint has been used for many years with a good success rate. However, the larger size of the joint tends to create more noise under traffic.
SARADHI Elastomeric joints are normally supplied in unit length and fixed to the deck using bolt anchors. If required tensioned cast iron bolts should be used to anchor this joint. If site drilled installations are used, the holes should be under reamed prior to fixing the bolts. An adequate length of the bolt should be de-bonded so that any relaxation over the bolt length does not result in complete loss of tension in the bolt.
It provides unique properties to withstand high water pressure in combination with large movements in all directions.
It is an ideal solution for joints where large gap movements are expected as a result of temperature effects and/or settlement Omega profile can be manufactured in a variety of sizes to fit almost any application. It is ideal for Metro rail projects
